For example, if you have red and blue gimp, the order would be 'Red, Blue, Red, Blue'. Step 2: Arrange the gimp strands so that the colors alternate. Usually, 60-80 inches (150-200 cm) per strand is adequate depending on how long you want the bracelet to be. Step 1: Start by cutting four equal lengths of gimp. Gimp (also called plastic lacing or boondoggle) in two different colors Here are the steps to make a basic box gimp bracelet:

It's also a good idea to experiment with different colors of GIMP cord to make your keychains more visually appealing.Ĭreating a box gimp bracelet, also known as a box stitch or square stitch bracelet, requires patience and attention to detail. Practice different knotting techniques to create unique designs. Remember to take your time and have patience while making the keychain. Your GIMP keychain is now complete and ready to be attached to your keys!.Trim any rough edges or excess melted parts.Press the melted end against a flat surface to flatten it and prevent it from fraying.Be cautious not to burn yourself or overmelt the cord. Take the lighter or matchstick and use it to slightly melt the end of the cord tail.Trim any excess cord, leaving a small tail.Once you have completed the desired length, secure the keychain by tying a final knot at the end.You can add beads or charms in between knots if you'd like to personalize your keychain. Continue knotting until you reach your desired keychain length.You can search for tutorials on how to tie these knots if you are unfamiliar with them.

You can use various knotting techniques like box knots, cobra knots, or square knots. Now, start creating knots using the cord.Pull the ends of the cord to tighten the loop around the keychain ring.Loop the middle point of the cord through the keychain ring, then pass the ends of the cord through the loop created.This will be where the keychain ring will attach. Fold the cord in half and find the middle point.Measure and cut the GIMP lanyard cord to your desired length, usually around 12 inches.

Here's a guide to help you create GIMP keychains: Making GIMP keychains requires a few materials and following a step-by-step process. A safety pin is usually helpful in loosening the first square knot so that it can be connected.Ĭontinue reading here: How to Make a Backwards Knot

It is possible to make a 'seamless' bracelet.

Children should have adult supervision however. You can also use a match to melt the ends together.

If you don't have super glue you can tie the ends together, but these can easily come out.

You can always continue work on it later.

If your fingers get tired or get blisters on them, take a break.

Remember to have extra gimp just in case you ruin some.

Beginning can be difficult and take lots of practice.

If that happens take out that row and redo it. It is easy for you to get your string twisted. Super glue the ends together and then slip it around your wrist. Tie a knot at the end or melt the end with a match Make the gimp sinnet (chain of knotted gimp) as long as it needs to be (use a measuring tape on your wrist and add an inch). Do the same pattern on the rest, over first under second, over first under second, pull tight.

Easy gimp bracelets for begginers